Airmar B75C-20-M 20d Tilt With Garmin 8-Pin MM Cable

Airmar B75C 20° Tilted Element Medium CHIRP Bronze Thru Hull transducer comes with an 8-Pin Garmin Mix-N-Match Cable. Model: B75C-20-M-8G. It's a depth and fast-response water-temperature sensor. With just one transducer, you get 50 kHz of total bandwidth. Ideal for all fishing enthusiasts, be it commercial fishermen, charter captains, or tournament anglers. CHIRP transducers offer bottom detection up to 3,000m (10,000') with 5 - 10 times more detail. One installation gives up to 80 kHz of total bandwidth, saving your time and money. It can sound deeper than high - frequency transducers and has better resolution than low - frequency ones. It has a wider beam than high - frequency transducers, covering more area under the boat and increasing your chances of finding fish. Also, it provides clear images even at high boat speeds. Specifications: CHIRP Frequency: 80 kHz to 130 kHz; Beamwidth: 24° to 16°; Element tilt: 20°; Deadrise: 16° to 24°; Maximum depth: 900ft. What's in the box: B75C-20-M-MM and MMC-8G.

Using this Airmar transducer is easy. First, install it on your boat following the included instructions. Make sure to connect the Garmin 8 - Pin MM Cable properly. Once installed, turn on your fishing equipment and start using it for depth and water - temperature sensing. When you're out fishing, the transducer will help you detect the bottom and find fish. Remember to keep it clean after each use. Rinse it with fresh water to remove any salt, dirt, or debris. Store it in a dry place to prevent rust and damage. If you notice any problems or the performance is not as good as before, check the connections and cables. Don't use it in extremely rough conditions without proper protection, as it may affect its performance and lifespan.