Airmar B175C-12-H Thru Hull With 12-Pin Garmin MM Cable

The Airmar B175C High Frequency CHIRP Transducer is a top - notch choice for fishing enthusiasts. It comes with a 12 - degree tilted element and a 1 - meter Garmin 12 - pin M&M Chirp Cable. Model: B175 - C - 12 - H - 12G. This transducer CHIRPS from 130 kHz to 210 kHz with a 15° to 9° beamwidth, offering 80 kHz of total bandwidth from a single unit. It's suitable for fiberglass or wood hulls and boats up to 11 m (36’). It has a depth and fast - response water - temperature sensor, and a bronze transducer housing. Whether you're a commercial fisherman, charter captain, or tournament angler, this transducer provides bottom detection down to 3,000m (10,000’) with 5 to 10 times greater detail and resolution, allowing you to distinguish between different fish and underwater structures. One installation saves you time and money. It terminates with Airmar's Mix and Max connector, which can be cut off for sounders without connector requirements. Specifications include a hull deadrise of 8° to 15°, an acoustic window of urethane, a frequency range of 130 - 210 kHz. What's in the box: a B175 High Frequency Transducer and a 1 - meter Garmin 12 - pin M&M Chirp Cable.

Using this Airmar B175C transducer is easy. First, install it on your fiberglass or wood hull boat that is up to 11 meters long. Make sure the hull deadrise is between 8° and 15°. Connect the Garmin 12 - pin M&M Chirp Cable to your sounder. You can cut off the Airmar Mix and Max connector if your sounder doesn't need it. When you're out fishing, the transducer will start working right away, providing you with detailed information about the underwater world. As for maintenance, keep the transducer clean. After each use, rinse it with fresh water to remove any salt or debris. Check the cable regularly for any signs of damage. Store it in a dry place when not in use. And remember, this transducer can detect the bottom up to 3,000 meters deep, so use it to your advantage to find the best fishing spots.